Products > FMC230
Issues powering up FMC230 on a Vadatech carrier card
stanstanev:
Hi Peter,
I sent two boards to you last Friday. Can you give a firm date when we can get those back? Thanks
Stan
peter:
Stan,
Our plan is to ship this back on Friday or Monday.
Best Regards,
Peter
peter:
The boards were shipped back. Tracking number: 1ZA317W40393711031
Thank you, Peter
arnaudNL:
Stan,
Please let us know if the boards arrives and if you are satisfied with the results.
Best Regards,
Arnaud
stanstanev:
Hi,
boards arrived on Friday. I just tested them today. I was able to power them up through the carrier card, so that issue seems to have been fixed. An engineer will also run a firmware test to make sure the DACs are working properly as well.
Peter/Arnaud, could you also confirm if the same issue is present on the FMC160? The behavior that the carrier card is exhibiting during FMC configuration on start-up with this board is a little different than the FMC230 but the final result is the same. The board doesn't power up. If it's the same issue then we would like to have that fixed as well.
We also have 2 more FMC230 boards we would like to send back to you for RMA. Thanks
Stan
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version