Hi 4dsp,
I have generated default firmware for VC707 by StellarIP and downloaded it into FPGA. Then I tried to connect our board to the PC over Ethernet and have seen in the Ethernet Cart settings that connection had speed 100 Mbps but in the firmware and in the relevant docs says that speed must be 1 Gbps. When I open FMC30RFApp project and launch it, Wireshark captures some 5 outcoming packages from the FMC30RFApp to the FPGA, but VC707 don't response on the request of the sip cid table. I changed 4 Ethernet cables(cat.5e), install last drivers on ethernet card. Windows 7 is installed on PC.
When I downloaded default Xilinx firmare (XTP148, ethernet example for VC707) into FPGA, board was sending packages from interal(in FPGA) packet generator and we saw it in Wireshark.
Best regards, Dmitri.