Hello Torben,
I am not sure what you mean by "I do not get a link", on my side, tried the firmware (244_vc707_fmc126.bit, modified 10/10/2012). This is the firmware many customers are using just fine. Let me detail what I have done and what I could see:
1) The board is powered up, some of the LEDs on VC707 - Ethernet are lit.
2) Programming the board with JTAG, at this time the fan on VC707 goes down, then restarts. At the exact same moment, the PHY LEDs goes off and are lit again after about one second.
3) The software is ran, on my side did not attach FMC126 as I don't have any, used the following application arguments: FMC12xapp 1 VC707 1 0 0
4) On the output I see:
Number of devices found : 3
0. \DEVICE\{D34BC2E6-80CD-4C72-9CAB-326225B1BAEA}
- Broadcom 4313 802.11b/g/n
1. \DEVICE\{7120AB20-B4F4-4749-A995-3C8FB7B45B57}
- Intel(R) 82577LC Gigabit Network Connection
2. \DEVICE\{48D2E642-621A-4481-B0C5-E43185B05556}
- Microsoft Virtual WiFi Miniport Adapter
Start of program
--------------------------------------
Constellation ID : 244
Number of Stars : 5
Software Build : 0x5074C736
Firmware Build : 0x00000000
Firmware Version : 0.1
--------------------------------------
Found FMC126-VC707 hardware (Ethernet Firmware)
Could not detect FMC12x hardware, exiting
The only thing I can come up with is the link speed, it should be on a 1000 (gigabit) ethernet adapter, I believe there are some issues on 10/100 adapters.
Note that my "Local Area Connection" states "Unidentified network".
Maybe show me some codes or errors, I cannot do anything more with the information you provided.
Best Regards,
Arnaud