4DSP Support Forum
Products => FMC Products => FMC112, FMC116 => Topic started by: ethanzhu on July 24, 2014, 05:16 PM
-
When we test the demo project from the Page 61 of "4FM_Get_Started_Guide", we cannot program the FPGA through iMPACT.
The problem is if I just connect the FPGA to the laptop without plugging the FMC116 into FMC Port, I can program the FPGA quite well.
But when I plug FMC116 into FPGA, the iMPACT shows that:
PROGRESS_START - Starting Operation.
INFO:iMPACT:583 - '1': The idcode read from the device does not match
the idcode in the bsdl File.
INFO:iMPACT:1578 - '1': Device IDCODE : 00000000000000000000000000000000
INFO:iMPACT:1579 - '1': Expected IDCODE: 00000011011010000111000010010011
And also shows "Program failed"
I think the problem should be referred to "The attached FMC card must implement a TDI-to-TDO connection via a device or bypass jumper to ensure
that the JTAG chain connects to the FPGA U1." on the page 26 of "ug885_VC707_Eval_Bd".
But I don't find the bypass jumper, could you tell me which connector or jumper is on FMC116?
Or if this is not the solution of the problem, could you tell how can I fix that, please?
Ethan
-
Dear Ethan,
Please do not double post on both private/public area. This does not speed up the process, I am locking this topic.
Best Regards,
Arnaud
-
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.