4DSP Support Forum

Products => FMC Products => FMC30RF => Topic started by: kcfarleyswmacb on October 01, 2013, 01:14 PM

Title: Getting Started with ML605 and FMC30RF
Post by: kcfarleyswmacb on October 01, 2013, 01:14 PM

What are the steps to get up and running with ML605 board and FMC30RF.  I've been going through "4FM Getting Started Guide" and haven't found the simple steps to get up and running with the ML605 and FMC30RF combo?

Title: Re: Getting Started with ML605 and FMC30RF
Post by: Kyu on October 02, 2013, 11:55 AM

Hi,


Please refer chapter 8 in the 4FM getting started guide. It describes how you can run a reference design.


Thanks,
Kyu