4DSP Support Forum

Products => FMC Products => FMC30RF => Topic started by: rvincentzio on February 19, 2013, 08:34 PM

Title: Simulator in ISE 14.4
Post by: rvincentzio on February 19, 2013, 08:34 PM

I am following the steps of 4FM Getting Started Guide. The section 2.4, Software Requirements (Modelsim...) talks about configuring the Modelsim. In the ISE 14.4 that comes with my KC705 the simulation lib. compilation wizard is under the ISE Design Tools, 32 bit tools. But when I start it I am getting the attached tab. Please advice how to proceed with the configuration.

Title: Re: Simulator in ISE 14.4
Post by: arnaudNL on February 22, 2013, 07:32 AM

Dear Sir,


We are phasing out modelsim because its price is ridiculous. For instance, the simulation is now done in ISIM typically for FMC30RF.


You can check the constellation documentation found in the firmware source code. There is the steps required for ISIM simulation described in there.


Best Regards,
Arnaud