4DSP Support Forum
Products => FMC Products => FMC30RF => Topic started by: stanstanev on December 11, 2012, 09:00 PM
-
Hi,
I installed the 4FM Dev Kit for the FMC30RF. I installed the reference firmware and ran the reference app but I couldn't find documentation (pdf file) for the reference design. I am trying to go through the C code to figure out divider ratios and such but I figured I would ask here for a quicker answer.
What does the reference design do? When it captures analog data what analog input port is used (RF In or RF I/O) and what is the TRF3765 PLL frequency?
Thank you,
Stan
-
Hello Stan,
Please find an answer to this question there: http://www.4dsp.com/forum/index.php/topic,1629.0.html
Best Regards,
Arnaud
-
Thank you, Arnaud!
Best,
Stan