4DSP Support Forum

Products => FPGA Products => Topic started by: filippo speziali on April 30, 2014, 09:13 AM

Title: problems on getting started with FM780+FM110
Post by: filippo speziali on April 30, 2014, 09:13 AM

Dear Sir/Madam

Today we received at Aresys our FMC780+FMC110 card mounted on a technobox 5933 PCIe adapted.

We inserted the module on a PCIe slot of an HP workstation.

The problem we see by inspection is that LEDs are signallings some failures.

CPLD LED 1 and CPLD LED2 are flushing fast, while all the other LEDS are OFF.

Of course Windows do not detect anything on the PCI bus

Do you have any suggestions on how to proceed?

Regards
Filippo Speziali

Title: Re: problems on getting started with FM780+FM110
Post by: ebarhorst on April 30, 2014, 11:31 AM

Hi Fillipo


can you try to restart your computer and see if the FM780 gets detected? Sometimes the BIOS is too fast in enumerating the PCIe bus and the board will not show until you restart


thanks,
Erik

Title: Re: problems on getting started with FM780+FM110
Post by: filippo speziali on April 30, 2014, 11:58 AM

Dear Erik,

I tried to restart the PC as you suggested but the same behaviour occurs.

Led are still blinking

thanks
Filippo

Title: Re: problems on getting started with FM780+FM110
Post by: arnaudNL on May 08, 2014, 07:00 AM

Dear Sir,


Just wanted to close this topic as the issue was asserted on your private forum area.


Best Regards,
Arnaud

Title: Re: problems on getting started with FM780+FM110
Post by: arnaudNL on May 08, 2014, 07:01 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.