4DSP Support Forum
Public Access => General Discussion => Topic started by: stanstanev on August 10, 2012, 02:32 PM
-
Hi,
I am having a difficult time figuring out whether either of the two HPC FMC slots on the series 7 VC707 carrier card can be configured to output levels of LVDS_25. From all the documentation that I've read for VC707 it looks like all the pins on the FMC slots are connected to an adjustable voltage but only a maximum of 1.8V.
Have you been able to run any of your daughter cards that are compatible with ML605 on a VC707 board? If so could you provide information on how to adjust the supply voltage of the banks that are routed to the FMC slots to LVDS_25.
Thanks
Stan
-
Dear Stan,
The FMC110 and a lot of cards are not compatible with the VC707. We are redesigning the FMC110 so it can cope with that.
Best Regards,
Arnaud
-
Arnaud,
do you know when an FMC204 compatible with VC707 will be available?
Thanks
Stan
-
Hello Stan,
FMC204 is a half of FMC110 but the same PCB, I am not able to tell you much about the time required but we are waiting our first batch!
You might want to ask my sales colleague about that!
Best Regards,
Arnaud
-
All 4DSP FMC products that were affected by the lack of 2.5V I/O support on the Virtex-7 have now been released and are compatible with the Virtex-7. Please see attached Product Change Notification for details.