4DSP Support Forum
Products => FMC Products => FMC150 => Topic started by: mCezar on May 20, 2014, 09:50 AM
-
Hello,
Although Xilinx and 4DSP say FCM150 supports VC707, it does not seem like that in the 4FM FMC Analyzer. I select FMC150 for card and VC707 for carrier, but then no available interface can be chosen (see the image).
This is somehow confirmed in the table present on page 27 of the "4FM Get Started Guide".
How can I have them work together inside this software?
Best,
Cezar
-
Dear Cezar,
The analyzer is not supported by all the platforms indeed.
The analyzer is based on the source code (C:\Program Files (x86)\4dsp\FMC Board Support Package\Refs\Software or C:\Program Files (x86)\4dsp\4FM Core Development Kit\Plug-Ins) of the FMC15xApp software application.
FMC15xApp is able to configure the whole chipset as well as save samples to a file by mostly writing 32 bit words to the firmware at given addresses.
I hope that helps!
Best Regards,
Arnaud
-
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.