4DSP Support Forum

Products => FMC Products => FMC150 => Topic started by: burselam on November 25, 2014, 07:15 PM

Title: Vivado Support for FMC150
Post by: burselam on November 25, 2014, 07:15 PM

Hi.
Does Stellar IP support Vivado project? How can I generate Vivado project with stellar ip?

Title: Re: Vivado Support for FMC150
Post by: arnaudNL on November 27, 2014, 06:49 AM

Dear Sir,


StellarIP have an early Vivado projects but only if the firmware itself supports it. And so far we are not preparing firmwares for Vivado except for large Virtex 7 FPGA as the 1140t because they are not support on ISE.


The ultrascale platforms we are using also are on Vivado because ultrascale are not supported on ISE.


We have no plan on back porting all our firmware to Vivado.


This being said, StellarIP creates an ISE project and Xilinx have a lot of literature and training on how to convert an ISE project to Vivado flow.


Best Regards,
Arnaud

Title: Re: Vivado Support for FMC150
Post by: arnaudNL on December 01, 2014, 08:43 AM

Dear Sir,


Was the information sufficient? May I a go ahead and close this topic? Feel free to open any new topic for other issues.


Best Regards,
Arnaud

Title: Re: Vivado Support for FMC150
Post by: arnaudNL on December 03, 2014, 07:34 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.