4DSP Support Forum

Products => FMC Products => FMC112, FMC116 => Topic started by: msdey123 on May 23, 2014, 08:43 AM

Title: STELLER IP
Post by: msdey123 on May 23, 2014, 08:43 AM
Today I installed steller ip.I bought FMC112 AND ML605 ,I need more guides , I could  not make *.TCLib. Help!!
Title: Re: STELLER IP
Post by: arnaudNL on May 23, 2014, 10:01 AM
Dear Sir,


Could you please describe the step you have taken as well as describe the actual error?


I will be glad to help you out


Best Regards,
Arnaud
Title: Re: STELLER IP
Post by: msdey123 on May 26, 2014, 05:20 AM
I am not able to bring the stellar ip lib in the left side of the GUI.I think I need some example to get it familiar.
Is it possible for you to send video tutorial of stellar ip full?
Title: Re: STELLER IP
Post by: arnaudNL on May 26, 2014, 05:58 AM
Dear Sir,


These steps are well covered by both the 4FM Getting Started Guide manual and the help in StellarIP. Try to press F1 key when you are in StellarIP.


Getting started > Firmware creation > 1.2


Also, try to be more descriptive with what does not work, which steps you have taken and where does it fail because without this information I simply cannot help you out efficiently and the quality of technical support will decrease because of that.


Best Regards,
Arnaud
Title: Re: STELLER IP
Post by: arnaudNL on June 13, 2014, 08:04 AM
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.