4DSP Support Forum

Products => FMC Products => FMC30RF => Topic started by: alexandre on January 29, 2014, 12:33 PM

Title: TX and RX path
Post by: alexandre on January 29, 2014, 12:33 PM

Hi,

i have some questions about the RX and TX path :

1) is there any filter at the TX DAC output ?

2) what are the part# for the LNA and PGA in the RX path ?

regards

Title: Re: TX and RX path
Post by: george.bishop on January 29, 2014, 05:16 PM

Alexandre-


1)  There is a low pass filter at the output.


2)  There are two fixed gain LNAs (SKY67101-396LF) and a programmable attenuator (SKY12329-350LF).

Title: Re: TX and RX path
Post by: alexandre on January 30, 2014, 06:09 AM

thanks for your answer.

Do you know the filter's bandwith ?

regards.

Title: Re: TX and RX path
Post by: george.bishop on February 03, 2014, 12:04 PM

The bandwidth is approximately 70MHz.

Title: Re: TX and RX path
Post by: arnaudNL on June 13, 2014, 07:13 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.