4DSP Support Forum

Products => Board Support Package (Installation, Licensing, ...) => Topic started by: mahturk on January 29, 2014, 06:28 AM

Title: refence firmware - output folder
Post by: mahturk on January 29, 2014, 06:28 AM

Hello,


When i installed my licensed firmwave (ml605+fmc104), i see that the output folder in the extracted firmwave top folder is empty. I think i should do some other things to fill the output folder with useful xilinx project that contains all other sub modules. How can i fill output folder?


Thanks.

Title: Re: refence firmware - output folder
Post by: arnaudNL on February 05, 2014, 06:17 AM

Dear Sir,


The 4FM Getting Started Guide is covering that; You've got to use StellarIP in order to create the ISE project in the output folder.


Thanks,
Arnaud

Title: Re: refence firmware - output folder
Post by: arnaudNL on April 01, 2014, 08:01 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.