4DSP Support Forum
Products => FMC Products => FMC150 => Topic started by: richt@kumunetworks.com on November 25, 2013, 02:30 PM
-
Again, I have several FMC150-2-1-1-1 boards I need to rework, so I need the layout assembly drawing.
The FMC150 board does NOT have reference designators for the bulk of the components, so it is very difficult to figure out the required reworks.I need at lease a good assembly drawing with all the component reference designators shown.
How do I get this?
-
Hi,
that information is not freely available. You will need to contact your sales representative for more information.
4DSP does not allow modifications to the board without voiding the products warranty.
best regards,
Erik
-
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.