4DSP Support Forum
Products => FMC Products => FMC150 => Topic started by: Juergen on October 22, 2013, 12:53 PM
-
Hello
According to the schematics of FMC150 r2.1 (see http://www.4dsp.com/forum/index.php/topic,2161.0.html (http://www.4dsp.com/forum/index.php/topic,2161.0.html)) there is a Dip Switch J17 for controlling WP/CDCE_MODE/CDCE_AUX settings, but I am not able to locate the switch on the board. So my questions are: - Is J17 populated on r2.1?
- Can you provide me with an assembly plan of r2.1?
Thank you,
Juergen
-
Dear Juergen,
No J17, is not populated the complete chip configuration is done by a software through the firmware during run time.
We don't have an assembly plan as soldering/modifying the board will void the warranty.
Best Regards,
Arnaud
-
Dear Arnaud,
What happens if these pins are short-circuitted? Is it possible,
to drive CDCE_MODE low, and enable configuration default on
CDCE this way? (Supposing there is no connection of the pin on LPC)
regards
Chris
-
Hello Chris,
The FMC150 operation modes are given by the FMC150 user manual. Any soldering on the PCB will void the warranty.
Best Regards,
Arnaud
-
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.