4DSP Support Forum
Products => FMC Products => FMC122, FMC125, FMC126 => Topic started by: tmf7md on August 15, 2013, 12:37 PM
-
I have an FMC126 interfaced to a KC705 board. I am attempting to use the sample program from 4 DSP to output data via ethernet, but the device is not found. Steps I take to test include:
1. Program the xc7l325t device with the file 253_kc705_fmc126.bit using Impact. Do not program the other device listed, xc2c64a.
2. Attempt to read the device using the 4DSP command line program. See attached png. for the error.
After I program the device, the following ethernet lights illuminate: Half Duplex, 100 Mbps, RX
-
Hi,
I think you should use a command without brackets. Could you try "Fmc12xApp 1 KC705 3 0"?
Thanks,
Kyu
-
Thanks for the reply. You were correct that I needed to remove the brackets. I had used the command without brackets before, but I had a different error at that point apparently.
The sample program is now working and storing buffered results.
Thanks!