4DSP Support Forum

Products => FMC Products => FMC150 => Topic started by: nams on June 10, 2013, 08:57 PM

Title: data acquisition on a Kintex 7 DSP Kit with "FMC150"
Post by: nams on June 10, 2013, 08:57 PM

I have tried data acquisition on a Kintex 7 DSP Kit with "FMC150" using System Generator for DSP 14.3

but it seems like there is some problem on the IN_A channel of FMC150 card. IN_B channel is OK

there are unwanted peaks with acquired data of IN_A channel
 
is this hardware malfuction or misconfiguation?
 
please refer below attachments. thank you

Title: Re: data acquisition on a Kintex 7 DSP Kit with "FMC150"
Post by: arnaudNL on June 11, 2013, 06:06 AM

Dear Sir,


It look like you are facing timing issue in your FGPA design. Your best bet would be to contact Avnet which are actually selling the DSP Kit as well as providing technical support for this specific design.


Best Regards,
Arnaud