4DSP Support Forum
Products => Board Support Package (Installation, Licensing, ...) => Topic started by: arydin on May 06, 2013, 02:41 PM
-
Hi,
I am trying to bring up a ML605 board with a FMC12x. I have installed the package from http://www.4dsp.com/4fm/bsp.
I load ml605_fmc125.bit with iMPACT and then I run the Fmc12xApp.exe. But is says that it cannot detect FMC12x hardware.
C:\Program Files (x86)\4dsp\FMC Board Support Package\Bins>Fmc12xApp.exe 1 ML605 0 0 3
Number of devices found : 3
0. \DEVICE\{A511C787-6C07-4900-8B63-5F1BFD75B5B5}
- Intel(R) 82579LM Gigabit Network Connection
1. \DEVICE\{8B9089BA-233C-4BF1-A931-00895C3C778C}
- Juniper Network Connect Virtual Adapter
2. \DEVICE\{FD1DB180-4EBE-4A50-9FA8-D47C682F6BBA}
- Intel(R) Centrino(R) Advanced-N 6205
Start of program
--------------------------------------
Constellation ID : 104
Number of Stars : 6
Software Build : 0x4EBA4245
Firmware Build : 0x00000000
Firmware Version : 0.1
--------------------------------------
Found FMC125-ML605 hardware (Ethernet Firmware)
Could not detect FMC12x hardware, exiting
C:\Program Files (x86)\4dsp\FMC Board Support Package\Bins>
What am I doing wrong?
Thanks,
Andreas
-
Hello Andreas,
Make sure the FMC board is connected on the FMC-HPC connector.
Best Regards,
Arnaud
-
It turned out the the ML605 board I was using did not work. I tried with a second board and it worked.
Thanks,
Andreas