4DSP Support Forum

Products => Board Support Package (Installation, Licensing, ...) => Topic started by: miroandi on November 29, 2014, 04:07 AM

Title: Reinstallation is required for new license file?
Post by: miroandi on November 29, 2014, 04:07 AM

I have installed BSP with license file for FMC230.


If I have another license file for FMC126, then I need to reinstall BSP ?

Title: Re: Reinstallation is required for new license file?
Post by: arnaudNL on December 01, 2014, 06:45 AM

Dear Sir,


Yes and no, if the installer is still at the same location you should be able to "Modify" the installation as per another license file. Note that you can obtain full license files by registering both your product on the webform.


If the installer is not at the original location anymore you will need to uninstall and reinstall.


Best Regards,
Arnaud

Title: Re: Reinstallation is required for new license file?
Post by: arnaudNL on December 02, 2014, 05:12 AM

Dear Sir,


Were you able to move forward, was the information sufficient?


Best Regards,
Arnaud

Title: Re: Reinstallation is required for new license file?
Post by: arnaudNL on December 03, 2014, 07:33 AM

Dear Sir,


I will close the topic within 24 hours unless you have something to add. Feel free to open any new topic if you would need to do so!


Best Regards,
Arnaud

Title: Re: Reinstallation is required for new license file?
Post by: arnaudNL on December 05, 2014, 07:00 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.