4DSP Support Forum

Products => FMC Products => FMC150 => Topic started by: agoel on October 13, 2014, 02:53 AM

Title: Changing the Sampling Frequency of ADC (FMC150 r 2.1)
Post by: agoel on October 13, 2014, 02:53 AM

Sir,


ADC is sampling at the default. frequency.
I want a sampling frequency of 60 MSPS. How can it be done?


Akanksha

Title: Re: Changing the Sampling Frequency of ADC (FMC150 r 2.1)
Post by: arnaudNL on October 13, 2014, 05:24 AM

Dear Sir,


You can't unless you are using an external clock. You can only divide 491.52MHz by N as far as the internal clock is concerned.


Best Regards,
Arnaud

Title: Re: Changing the Sampling Frequency of ADC (FMC150 r 2.1)
Post by: arnaudNL on October 16, 2014, 09:59 AM

Dear Sir,


Was the information sufficient?


Best Regards,
Arnaud

Title: Re: Changing the Sampling Frequency of ADC (FMC150 r 2.1)
Post by: arnaudNL on October 20, 2014, 02:12 PM

Dear Sir,


I will proceed with closing this topic in 24 hours without news from your side.


Best Regards,
Arnaud

Title: Re: Changing the Sampling Frequency of ADC (FMC150 r 2.1)
Post by: arnaudNL on October 22, 2014, 04:13 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.