4DSP Support Forum

Products => FMC Products => FMC150 => Topic started by: jwdonal on May 07, 2014, 06:00 PM

Title: FMC151 Drop-in Replacement for FMC150?
Post by: jwdonal on May 07, 2014, 06:00 PM

If I have a working FMC150 reference design running on the Zedboard and I then replace the FMC150 with an FMC151 will the FMC150 reference design still work but just have a DC-coupled output?  We do not want to switch to a different reference design if we move to the FMC151 card.  I am aware that the DC-coupled outputs are adjustable via an extra chip on the FMC151 but assuming that we do not care about adjusting the outputs is the FMC151 a simple drop-in replacement with no changes required in PC software, Zynq software, or HDL from original FMC150 reference design?

Title: Re: FMC151 Drop-in Replacement for FMC150?
Post by: arnaudNL on May 08, 2014, 08:48 AM

Dear Sir,


This is the idea indeed. The offset compensation chips are on the i2c bus so the software modification to do so would be pretty straightforward. It should be a drop in replacement assuming indeed.


Best Regards,
Arnaud

Title: Re: FMC151 Drop-in Replacement for FMC150?
Post by: arnaudNL on June 13, 2014, 07:55 AM

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.