4DSP Support Forum
Products => FMC Products => FMC150 => Topic started by: reza_m2rn on February 14, 2014, 05:31 PM
-
Hello
I am working on FMC150 coupled with ML605 board and my problem is when I modify the DAC input to generate low frequency RAMP
signals (<10Khz) the output signal gets filtered. I think the very end AC coupling causes this effect.
I was wondering if there is any way that I can fix this problem?
Your prompt response is highly appreciated.
Reza
-
Dear Reza,
You might want to look at the FMC151. This is a board we are about to release to public. This is more or less an DC coupled FMC150.
Best Regards,
Arnaud
-
Thanks for your reply.
Is there any way that I can take out the AC Coupler transformer at the end of DAC output path?
Reza
-
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.