4DSP Support Forum
Products => Virtex-6 and Kintex-7 DSP Kits => Topic started by: RuFuSS on March 13, 2012, 12:25 AM
-
Hello,
I've been working with the FMC150 and have managed to get everything operational except the the ADC chip. No matter what I've done, the chip remains silent.
I believe the cause is that the input pins have been shorted to the grounds at the grounds.
Any steps that need to be taken to resolve this?
Thanks,
RuFuSS
-
Hello,
Have you tried using the reference design delivered along with the FMC? What is your target hardware?
Thank you
Pierrick
-
I am connecting to the ML605, and using a reference design provided by avnet.
-
If the board does not operate properly with the reference design then you should request an RMA through Avnet.
Thanks
Pierrick
-
The board was purchased through 4DSP, the avnet reference design was just made available.
-
In that case, have you tried running the 4DSP reference design as well?
-
Currently I have not done the 4DSP reference design due to inability to follow any documentation on it.
Avnet's design was followed because of the clear order in operation.
Where can I find the 4DSP reference design?
-
I have already installed the package that was sent to me in an email.
I guess my question should have been: what is the top level file so that I can open it with xilinx?
-
Please refer to http://www.4dsp.com/pdf/FMC_Reference_Design_quick%20start_guide.pdf (http://www.4dsp.com/pdf/FMC_Reference_Design_quick%20start_guide.pdf)
-
The 4DSP reference design was run and clear input was seen through the ADC. Still trying to debug my code now.