Topic: analog filters on FMC150 board  (Read 12558 times)

JohnE March 13, 2012, 07:16 PM

  • Member
  • *
  • Posts: 12
Perhaps I am being thick, but I do not see the characteristics of the analog input filter for the ADC. Are you using something similar to the 5th order 82MHz Chebyshev LPF mentioned for the DAC? What about the low-frequency attenuation from the transformers? Is this documented anywhere?

pierrehic March 13, 2012, 08:55 PM (#1)

  • 4DSP Staff (USA)
  • Administrator
  • Member
  • *****
  • Posts: 875
There is no low pass filter on the A/D path. Please refer to the attached schematics.
For the main analog characteristics of the FMC150 you may also refer to paragraph 4.3 of the user manual: http://www.4dsp.com/pdf/FMC150_user_manual.pdf

JohnE March 14, 2012, 01:02 PM (#2)

  • Member
  • *
  • Posts: 12
Thank you for your prompt and helpful response.

Do you have additional information regarding the low-frequency rolloff imposed by the transformers?



pierrehic March 14, 2012, 01:17 PM (#3)

  • 4DSP Staff (USA)
  • Administrator
  • Member
  • *****
  • Posts: 875
Please refer to transformer datasheet: http://www.minicircuits.com/pdfs/TC1-1T+.pdf 
  • « Last Edit: March 14, 2012, 01:20 PM by pierrehic »

goel@ti.com May 30, 2013, 11:27 AM (#4)

  • Member
  • *
  • Posts: 1
We have two generations of FMC150 rev1.2 and rev2.1. Is it possible to get schematics for both and functionality differences between them? Thanks.


Manish

arnaudNL June 07, 2013, 05:16 AM (#5)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Manish,


Sorry for the late answer, I failed receiving the notification.


Please find both schematics attached, they are public domain.


Best Regards,
Arnaud

arnaudNL June 07, 2013, 05:18 AM (#6)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
The 2.1 schematic is not yet available.