Products > Virtex-6 and Kintex-7 DSP Kits

Need help with ADC

(1/2) > >>

RuFuSS:
Hello,


I've been working with the FMC150 and have managed to get everything operational except the the ADC chip. No matter what I've done, the chip remains silent.


I believe the cause is that the input pins have been shorted to the grounds at the grounds.


Any steps that need to be taken to resolve this?


Thanks,
RuFuSS

pierrehic:
Hello,

Have you tried using the reference design delivered along with the FMC? What is your target hardware?

Thank you
Pierrick

RuFuSS:
I am connecting to the ML605, and using a reference design provided by avnet.

pierrehic:
If the board does not operate properly with the reference design then you should request an RMA through Avnet.

Thanks
Pierrick

RuFuSS:
The board was purchased through 4DSP, the avnet reference design was just made available.

Navigation

[0] Message Index

[#] Next page