Products > Virtex-6 and Kintex-7 DSP Kits
Need help with ADC
RuFuSS:
Hello,
I've been working with the FMC150 and have managed to get everything operational except the the ADC chip. No matter what I've done, the chip remains silent.
I believe the cause is that the input pins have been shorted to the grounds at the grounds.
Any steps that need to be taken to resolve this?
Thanks,
RuFuSS
pierrehic:
Hello,
Have you tried using the reference design delivered along with the FMC? What is your target hardware?
Thank you
Pierrick
RuFuSS:
I am connecting to the ML605, and using a reference design provided by avnet.
pierrehic:
If the board does not operate properly with the reference design then you should request an RMA through Avnet.
Thanks
Pierrick
RuFuSS:
The board was purchased through 4DSP, the avnet reference design was just made available.
Navigation
[0] Message Index
[#] Next page
Go to full version