Products > FMC150
AC coupling effect of ADC
(1/1)
fmcuser:
I am using an ADC of FMC150 on ML605. The ADCs on FMC150 are AC coupled. There are capacitors in front of these ADCs. I input multiple waveform e.g. 100-kHz square pulses to one of the ADCs. The waveform that were sampled by the ADC was distorted. I think this is due to the frequency characteristics of the capacitors in front of the ADC.
Can anybody give me any advice to remove this AC coupling effect?
arnaudNL:
Dear Sir,
Not as I am aware of. The most obvious solution is to use a DC coupled card, the FMC151 is the DC coupled version of the FMC150.
Best Regards,
Arnaud
arnaudNL:
Dear Sir,
Do you need any more information about this issue before I close this topic?
Best Regards,
Arnaud
arnaudNL:
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
Navigation
[0] Message Index
Go to full version