Public Access > Forum Help
CONFUSION IN THE USER MANUAL OF FMC112
mhada:
yes arnaud,
Thanks for support.
mhada:
Hi Arnaud,
One more final doubt before you actually close the post i.e. why the driver circuit and ADC inputs have been in reverse polarity i.e. a polarity twist. What is the intention of doing this?
arnaudNL:
Mohit,
Yes, we took the decision to get better signal integrity on the PCB. It was better to swap the pairs in order to get a better routing.
This is of course not a mistake, this was done for the sake of effective number of bits and general integrity.
Let me know if I can close the topic.
Best Regards,
Arnaud
mhada:
ok thanks.
arnaudNL:
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
Navigation
[0] Message Index
[*] Previous page
Go to full version