Public Access > Forum Help


(1/2) > >>


We have gone through the user manual of FMC112 i.e. UM012 and we are confused as to what exactly the trigger signals doing and where exactly are they connected in the block diagram? How they are helping in customized sampling?

Again we are not clear as to what is the role of VADJ from the user manual. Kindly explain.

Is the EEPROM and the ADT7411 sharing common bus - I2C on board or not?

Dear Sir,

- The trigger goes to the FPGA through the FMC connector. It allows you to decide when you trigger, it is an external trigger, similar to what a trigger input is on an oscilloscope.
- VADJ is defined by the FMC specification. It is stands for Voltage ADJustable. This voltage comes from the FPGA carrier board and power some IOs. Generally VADJ also power the FPGA banks so there is compatibility between the FMC board IOs and the FPGA IOs.
- Yes, both EEPROM and ADT7411 shares the same i2c bus. The i2c bus pins on the FMC connector is also defined by the FMC specifications.

I hope that helps!

Best Regards,

Hi Arnaud,

Thanks for the reply.

You mean to say that Trigger signal enters through the front panel samtec connector and passes directly to FPGA [AND VICE VERSA FOR TRIGGER OUT] without being electrically touched on the FMC cards.

Again can you tell us what all IOs are powered by VADJ?


The trigger input goes from the panel connector to a single-ended to LVDS converter and is then directly connected to CLK1_M2C_P/N of the FMC connector. The recommended logic standard is LVTTL. For the trigger output, please refer to section 4.4.2 of the user manual (r1.6).

Please refer to table 9 in the user manual to see which IOs are powered by VADJ. For more information about VADJ I would recommend you to read FMC related documentation such as AV57.1.

Best regards,
Ingmar van Klink

Dear Mohit,

Please let me know if the information was sufficient and if we can go ahead and close this specific topic.

Best Regards,


[0] Message Index

[#] Next page

Go to full version