Topic: Stellar IP Design  (Read 35883 times)

arnaudNL March 17, 2015, 07:37 AM (#30)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Joao,


The ADC always output samples but the acquisition only happens after sending a software (or hardware) trigger.


Moving the FMC150App code to Zynq is doable, will require a bit of efforts but something that can be done.


I hope that helps,


Best Regards,
Arnaud


PS: We are moving away from the forum towards a ticket system on support.4dsp.com, feel free to register there and post continuation posts if you need. I assume I can close this topic in the meanwhile?[size=78%] [/size]

JoaoFerreira March 17, 2015, 12:16 PM (#31)

  • Member
  • *
  • Posts: 31
Ok you can close this topic. I'll use the ticket system

arnaudNL March 19, 2015, 06:17 AM (#32)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.