Products > FMC150

Stellar IP Design

<< < (7/7)

arnaudNL:
Dear Joao,


The ADC always output samples but the acquisition only happens after sending a software (or hardware) trigger.


Moving the FMC150App code to Zynq is doable, will require a bit of efforts but something that can be done.


I hope that helps,


Best Regards,
Arnaud


PS: We are moving away from the forum towards a ticket system on support.4dsp.com, feel free to register there and post continuation posts if you need. I assume I can close this topic in the meanwhile?[size=78%] [/size]

JoaoFerreira:
Ok you can close this topic. I'll use the ticket system

arnaudNL:
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.

Navigation

[0] Message Index

[*] Previous page