Products > FMC112, FMC116

Configuring ADC

<< < (2/2)

karen:

because you are the writer of the code on PC side, my impression was you should be crystal clear what your code does on FPGA!


feel free to close the topic.

arnaudNL:
Dear Karen,


Don't be fooled by the appearance. I haven't wrote the code. The code was based on a framework I wrote back in 2010 and was created on October 7 2011 by an engineer in Austin. The engineer was probably a bit shy and kept my names in there...


I feel sorry I could not meet your expectations and provide you a table we don't have. I offered you two options at the time, create the table on your side or get 4DSP to provide you with this table. In this case someone would need to sit and create this table and this will have a cost.


Please keep in mind the reference design is free of charge so do the standard technical support forum. The reference design comes in source code and with documentation.


Best Regards,
Arnaud

arnaudNL:
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.

Navigation

[0] Message Index

[*] Previous page