Dear Sir,
Thank you for your quick reply.
The whole Board Support Package is huge with respect to its utilities. And it has so many entry points say C codes, dsn files, vhdl files, doxygen etc.
When I went through it for the first time say a few days ago, I dint understand where to begin from, following which I went to forum & got a start.
So what I did is the following (Taking ref. from the documentation and the forum) (In sequence) :
0) Trying out the FMC Analyzer thing after dumping .bit file - which dint work. So discarded.
1) Loading the legacy library xml file and the dsn file for mL605_fm150 into Stellar IP.
2) Generated, without making any changes (from stellar ip tab), the .xise project, which is again a big thing to go through.
3) Started going through schematics of FMC150 (which again was posted by you somewhere), to understand the design..
4) As you suggested, I just went through the doxygen. (WinPcap, I installed earlier).
I am not able to figure out how to use the C Code. Do I need it to configure ADC wrt Sampling Rate, Output Bit width, with the procedure of which I am still not aware.
I am a newbie here. Please help me out.
Thanks a lot,
Akanksha