Products > FMC150

StellarIP_Interface_to_Axi_Interface document

(1/2) > >>

JoaoFerreira:
Hello


I want to ask if it is possible to follow this guide doing the samething with zedboard and FMC150.
If that is possible, is there something i need to take care when following the guide?


Thanks
Joao

arnaudNL:
Dear Joao,


This should be all right; some other customers implemented support on other carriers by following this guide.


Best Regards,
Arnaud

JoaoFerreira:
Ok but basically i can follow this guide and implement the ref design given by 4dsp to fmc150 in vivado.
The only difference here is that the ref design in the guide of fmc110 that is build to be able to configure the clock tree, ADCs and DACs as well as capture data from the ADC and send data to the DAC.
And the FMC 150 ref. design its loading data to DAC and send it to ADC, is that correct?[size=78%] [/size][/size][size=78%] [/size]

arnaudNL:


Dear Joao,


The AN contains some FMC110 modified support files. You will need to create a set of support files for FMC150, typically you will need to create an xdc file for Vivado as we only have ucfs for ISE.


Note that 4DSP can provide engineering services which go on top of the free reference design provided to our customers. Maybe we could provide you with an AN for your exact hardware combination. You should expect some costs for that. is it a path you are interested by? Shall I get one of our sales engineering in touch with you?


As a firmware engineer it should not be that difficult to look at this AN, the default firmware and implement what you want on top of that, the sky is the limit! Once again many other customers have done that already


Thanks,
Arnaud

JoaoFerreira:
I'll try to figure out then.


Thanks for the explanation

Navigation

[0] Message Index

[#] Next page