Topic: Software Triggering on FMC168 card  (Read 1845 times)

deeponglu January 15, 2015, 01:58 PM

  • Member
  • *
  • Posts: 16
Hi All,


I am trying to analyze the synchronization among channels in the FMC168 card. Does anyone know whether the software trigger simultaneously enables sampling on all 8 channels? I would like to send one trigger and then slowly read each channel from the FIFO. It's not clear from the reference firmware whether all channels are acquired in parallel.


Regards,
Daniel

arnaudNL January 19, 2015, 07:07 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Daniel,


No, nothing was taken care of about synchronous aspect. The reference firmware is a simple layer able to evaluate our platforms but not a full blown implementation taking channel synchronously. You will need to modify both the reference firmware and software in order to do that.


Best Regards,
Arnaud

arnaudNL January 21, 2015, 06:41 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Daniel,


Please let me know if the information was sufficient or do you need extra information before I close this specific topic.


Best Regards,
Arnaud

deeponglu January 21, 2015, 03:15 PM (#3)

  • Member
  • *
  • Posts: 16
Hi Arnaud,


You can close this topic.


Thanks,
Daniel

arnaudNL January 22, 2015, 08:06 AM (#4)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.