Products > FMC103, FMC104, FMC107, FMC108
maximum/nominal analog Input Common Mode Voltage (FMC104-2-2-4-1)
(1/1)
fmc104user:
Dear 4DSP team,
i have a question about the FMC104-2-2-4-1 board (diff. analog Inputs). What is the maximum & nominal Common Mode Voltage to GND of the differential analog input? I cannot find this Value in the User Manual (only the Value for the diff. Input Range 2Vpp).
Thanks for your Help!
Jonas
iklink:
Dear Jonas,
The maximum common mode voltage is +3.3V, but in this case your signal amplitude must be 0V. The recommended common mode voltage is +1.65V (referred to ground).
Best regards,
Ingmar van Klink
4DSP
arnaudNL:
Dear Jonas,
Let us know if the information was sufficient, if so I will close this topic.
Best Regards,
Arnaud
arnaudNL:
Dear Jonas,
I will close this topic in 24 hours unless you have anything more to add!
Best Regards,
Arnaud
arnaudNL:
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
Navigation
[0] Message Index
Go to full version