Topic: maximum/nominal analog Input Common Mode Voltage (FMC104-2-2-4-1)  (Read 8078 times)

fmc104user January 14, 2015, 05:52 AM

  • Member
  • *
  • Posts: 1
Dear 4DSP team,
 i have a question about the FMC104-2-2-4-1 board (diff. analog Inputs). What is the maximum & nominal Common Mode Voltage to GND of the differential analog input? I cannot find this Value in the User Manual (only the Value for the diff. Input Range 2Vpp).

Thanks for your Help!
Jonas
 

iklink January 19, 2015, 10:33 AM (#1)

  • 4DSP Staff (EU)
  • Member
  • *
  • Posts: 153
Dear Jonas,


The maximum common mode voltage is +3.3V, but in this case your signal amplitude must be 0V. The recommended common mode voltage is +1.65V (referred to ground).


Best regards,
Ingmar van Klink
4DSP

arnaudNL January 21, 2015, 06:36 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Jonas,


Let us know if the information was sufficient, if so I will close this topic.


Best Regards,
Arnaud

arnaudNL January 22, 2015, 08:20 AM (#3)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Jonas,


I will close this topic in 24 hours unless you have anything more to add!




Best Regards,
Arnaud

arnaudNL January 26, 2015, 06:09 AM (#4)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.