Hello,
I am attempting to run the 4FM FMC Analyzer on my VP780 with an FMC176 installed. Earlier today I downloaded and installed v2.250.1 of the BSP software. I am running the VP780/FMC176 reference design (Constellation ID 294) using its recovery .hex file, found at:
C:\Program Files (x86)\4dsp\Common\Firmware\Recovery\294_vp780_fmc176\294_vp780_fmc176_1140t.hex
So I've loaded this .hex file into FPGA A, and power-cycled the board, as instructed to do by the 4FM GUI Application. I then opened 4FM FMC Analyzer, and selected the following items:
-FMC Card: FMC176
-Carrier: VP780
-Available Interfaces: PCIe
-Device to connect: Device 0
-Clock Mode: Internal Clock
I clicked "Open Device" and got the following error message in a popup dialog:
"FMC card initialization error: Unable to connect to FPGA device. Perhaps an incorrect device id was used or incorrect firmware was loaded?"
The console window that opened up when I clicked "Open Device" contains the following text:
" [size=0pt]Connected FPGA Device Type: XC7VX1140T-2FXG1930C
Start of program
--------------------------------------
Constellation ID : 294
Number of Stars : 8
Software Build : 0x540968FD
Firmware Build : 0x00000000
Firmware Version : 0.257
--------------------------------------
Constellation ID not supported by this software, exiting...[/size]"
Is this constellation supported by 4FM FMC Analyzer? Have I done something incorrectly in attempting to run this firmware/software? Is there a different constellation that I should be using instead?
Thank you!
Jim