Products > FMC150
FMC150 Configuration
Frank:
Hello,professor,I need your help!
I want to use ML605 to configurate the FMC150,
So can you tell me where I can download the reference
design?VHDL or Verilog is ok.
Thank you.
arnaudNL:
Frank,
The reference design is part of the BSP, you can register your products and obtain a bsp from http://www.4dsp.com/fmc/bsp
This location is printed on the packaging of all our FMC boards.
Best Regards,
Arnaud
Frank:
Thank you for your reply,I have downloaded the BSP already.
When I used the FMC Analyzer,I met some questions.
I used the Ethernet to connect ML605 with computer, but the
software showed there was no device connected.So I cannot open the FMC150 using the software.
Secondly, what I want is the original VHDL or Verilog program of ML605_FMC150.bit,so can you give it to me?
arnaudNL:
Frank,
Have you found the 4FM Getting Started Guide already (C:\Program Files (x86)\4dsp\4FM Core Development Kit\Documentation\4FM_Get_Started_Guide.pdf) ?
The document explains what is StellarIP: Chapter 4.2
The document indicates where the StellarIP firmwares are installed: Chapter 4.5
The document explains how to load a firmware in StellarIP and create an ISE project: Chapter 5.1.1 to 5.1.4
The document indicates that Ethernet based reference design cannot be used in the GUI on chapter 4.9
The document explains how to use the Analyzer: Chapter 4.9.5
The document explain how to run the reference software: Chapter 11.
I hope that helps!
Best Regards,
Arnaud
arnaudNL:
Dear Frank,
Was the information useful, are you able to move forward?
Best Regards,
Arnaud
Navigation
[0] Message Index
[#] Next page
Go to full version