Official schematics of FMC150 r2.1

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »

Pages: [1] Go Down

agoel October 15, 2014, 02:36 PM

Member
Posts: 13

Dear Sir,

Can u provide the schematics of FMC150 r 2.1.
And, are there any changes being done in Reference Design recently (I ask specifically for ML605).

Thank u very much,

Akanksha

Logged

arnaudNL October 16, 2014, 09:45 AM (#1)

4DSP Staff (EU)
Administrator
Member
Posts: 7110

Dear Akanksha,

Someone will provide you with the schematics ASAP.

As far as the ML605 is concerned, no recent updates.

Best Regards,
Arnaud

Logged

daniel.sill October 16, 2014, 09:49 AM (#2)

Member
Posts: 55

Schematic attached.

Logged

arnaudNL October 17, 2014, 11:31 AM (#3)

4DSP Staff (EU)
Administrator
Member
Posts: 7110

Dear Sir,

I assume this issue is answered properly. Is there anything else I can do around this issue before closing the topic?

Best Regards,
Arnaud

Logged

agoel October 17, 2014, 12:41 PM (#4)

Member
Posts: 13

No Sir. Thank you. You may close the topic.

Akanksha

Logged

arnaudNL October 20, 2014, 02:04 PM (#5)

4DSP Staff (EU)
Administrator
Member
Posts: 7110

Dear Akanksha,

Thanks for the feedback!

Best Regards,
Arnaud

Logged

arnaudNL October 20, 2014, 02:05 PM (#6)

4DSP Staff (EU)
Administrator
Member
Posts: 7110

This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.

Logged

Pages: [1] Go Up