These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: Changing the Sampling Frequency of ADC (FMC150 r 2.1)  (Read 4448 times)

agoel October 13, 2014, 02:53 AM

  • Member
  • *
  • Posts: 13
Sir,


ADC is sampling at the default. frequency.
I want a sampling frequency of 60 MSPS. How can it be done?


Akanksha
  • Logged

arnaudNL October 13, 2014, 05:24 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


You can't unless you are using an external clock. You can only divide 491.52MHz by N as far as the internal clock is concerned.


Best Regards,
Arnaud
  • Logged

arnaudNL October 16, 2014, 09:59 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


Was the information sufficient?


Best Regards,
Arnaud
  • Logged

arnaudNL October 20, 2014, 02:12 PM (#3)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


I will proceed with closing this topic in 24 hours without news from your side.


Best Regards,
Arnaud
  • Logged

arnaudNL October 22, 2014, 04:13 AM (#4)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016