Products > FMC204
Configure the FMC204 for using the AD9517 VCO
(1/1)
aberracasa:
I am looking for information on how to configure my FMC204 board to use the VCO inside the AD9517 PLL chip. When I received it, my board was configured to use the on-board 1GHz VCXO which I cannot use in my application. The mod involves the loop filter and probably requires moving a couple of zero ohm resistors.
Thanks
Andre
arnaudNL:
Dear Andre,
This is an manufacturing option we provide to customers (-C26) indeed. Modifying the PCB on your side will void the warranty so it is strongly advised to get us modify and qualify your board.
Are you interested by this, shall I get you a sales engineer to contact you ?
Best Regards,
Arnaud
aberracasa:
Hi Arnauld,
Thanks for the reply. I have received the C26 ECO from Dave Thompson.
Best regards,
Andre
arnaudNL:
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
Navigation
[0] Message Index
Go to full version