If I have a working FMC150 reference design running on the Zedboard and I then replace the FMC150 with an FMC151 will the FMC150 reference design still work but just have a DC-coupled output? We do not want to switch to a different reference design if we move to the FMC151 card. I am aware that the DC-coupled outputs are adjustable via an extra chip on the FMC151 but assuming that we do not care about adjusting the outputs is the FMC151 a simple drop-in replacement with no changes required in PC software, Zynq software, or HDL from original FMC150 reference design?