Topic: problems on getting started with FM780+FM110  (Read 8684 times)

filippo speziali April 30, 2014, 09:13 AM

  • Member
  • *
  • Posts: 16
Dear Sir/Madam

Today we received at Aresys our FMC780+FMC110 card mounted on a technobox 5933 PCIe adapted.

We inserted the module on a PCIe slot of an HP workstation.

The problem we see by inspection is that LEDs are signallings some failures.

CPLD LED 1 and CPLD LED2 are flushing fast, while all the other LEDS are OFF.

Of course Windows do not detect anything on the PCI bus

Do you have any suggestions on how to proceed?

Regards
Filippo Speziali

ebarhorst April 30, 2014, 11:31 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 1222
Hi Fillipo


can you try to restart your computer and see if the FM780 gets detected? Sometimes the BIOS is too fast in enumerating the PCIe bus and the board will not show until you restart


thanks,
Erik

filippo speziali April 30, 2014, 11:58 AM (#2)

  • Member
  • *
  • Posts: 16
Dear Erik,

I tried to restart the PC as you suggested but the same behaviour occurs.

Led are still blinking

thanks
Filippo

arnaudNL May 08, 2014, 07:00 AM (#3)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


Just wanted to close this topic as the issue was asserted on your private forum area.


Best Regards,
Arnaud

arnaudNL May 08, 2014, 07:01 AM (#4)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.