These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: FMC150 J17 Switch  (Read 4295 times)

burselam March 11, 2014, 01:09 PM

  • Member
  • *
  • Posts: 8
Hello;


There is a dip switch on schematic, J17 but my board don't have any dip switch.


So I don't know MODE_SEL and AUX_SEL status. What are they status of MODE_SEL and AUX_SEL ? How can I start my board with default configration (from CD1,CD2,CD3)


Thanks.
  • Logged

george.bishop March 11, 2014, 04:41 PM (#1)

  • Member
  • *
  • Posts: 24
Without the DIP switch populated, the CDCE72010 defaults MODE_SEL to high.  This selects the SPI bus interface mode and makes AUX_SEL a don't care.


Thanks,
George
  • Logged

arnaudNL June 13, 2014, 07:29 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016