These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: FMC125 calibration package for ML605 - library missing  (Read 4296 times)

daniels March 06, 2014, 03:34 PM

  • Member
  • *
  • Posts: 10
Hi,
I cannot find the 4DSPmai.TCLib in the (path)/star_lib  folder as indicated in pag. 43 of 4FM Get Started Guide, and therefore I cannot generate the ISE project. Actually when I start Stellar IP I got the message: "library not found"
  Please advise. (Obviously I had the respective license, we just bought the package from you)
Thanks
  • Logged

arnaudNL March 07, 2014, 05:45 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Hello,


The libraries are per project so you have one library per project, typically 400_kc705_trainmat\star_lib would have one.


If you are importing old design (with only sdf/xml file) then look at the chapter 8, it is about importing the legacy xml library and then importing the legacy sdf.


Best Regards,
Arnaud
  • Logged

arnaudNL June 13, 2014, 07:27 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016