Topic: I2C address of the I2C-bus to SPI bridge chip  (Read 3574 times)

ssasi February 24, 2014, 07:08 PM

  • Member
  • *
  • Posts: 17
Hello,


In Table 7 of the FMC12x manual, it states that the I2C addresses of the devices depend on global address pins (GA0, GA1).


How do I find out the values of GA0 and GA1 on my board? Are they certain pins on the FMC connector?


Thanks.

arnaudNL February 25, 2014, 09:01 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Sir,


Yes they are coming from the carrier via the FMC connector. On ML605 it is '0' for other boards you would need to consult schematics/user guides.


Best Regards,
Arnaud

ssasi February 25, 2014, 09:10 PM (#2)

  • Member
  • *
  • Posts: 17
Thanks, Arnaud. I find that they correspond to C34 and D35 on the HPC FMC pinout, and also called the Geographical Address pins.

arnaudNL February 26, 2014, 05:38 AM (#3)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.