These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: PCB assembly drawing and/or layout for the FMC150 board, how do I get it?  (Read 4567 times)

richt@kumunetworks.com November 25, 2013, 02:30 PM

  • Member
  • *
  • Posts: 4
Again, I have several FMC150-2-1-1-1 boards I need to rework, so I need the layout assembly drawing.
The FMC150 board does NOT have reference designators for the bulk of the components, so it is very difficult to figure out the required reworks.I need at lease a good assembly drawing with all the component reference designators shown.
How do I get this?

  • Logged

ebarhorst November 25, 2013, 07:23 PM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 1222
Hi,


that information is not freely available. You will need to contact your sales representative for more information.
4DSP does not allow modifications to the board without voiding the products warranty.


best regards,
Erik
  • Logged

arnaudNL November 26, 2013, 08:06 AM (#2)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
This topic is being closed because the issue is considered as resolved by 4DSP. Feel free to create a new topic for any further inquiries.
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016