These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016

« previous next »
Pages: [1]   Go Down

Topic: FMC125 Analog Input Bandwidth  (Read 4110 times)

Fernando November 13, 2013, 08:56 AM

  • Member
  • *
  • Posts: 3
After testing the FMC125 with some 625 Mbaud test signals we have experiencied some attenuation on the higher frequencies, probably due to the analog bandwidth of the FMC125. In the FMC122/FMC125/FMC126 User Manual it is referred that the analog bandwidth of the FMC is programmable (500/600/1500/2000 MHz). We would like to ask you which is the default analog bandwidth and how can we program it?


Best regards,
Fernando
  • Logged

arnaudNL November 13, 2013, 09:50 AM (#1)

  • 4DSP Staff (EU)
  • Administrator
  • Member
  • *****
  • Posts: 7110
Dear Fernando,


What the user manual says is that the e2v chip has a analog bandwidth setting. Check register 0x1, "Control Register" field "BDW".


Best Regards,
Arnaud
  • Logged
Pages: [1]   Go Up
« previous next »

These forums will be taken offline, effective March 13, 2015.
Ongoing support will be available at support.4dsp.com
Open support tickets on this forum will remain open with full support until May 31, 2015.
All topics will be archived and available until March 31, 2016